Technicolor Mediatune Guía de instalación descargar pdf (Pagina 5)

Technicolor MCS

101 W. 103

Indianapolis, IN 46290

www.technicolor.com/mcs

Configuring Mediatune

Mediatune will utilize all available HD tuners which can be accessed by the COM24 containing

the Mediatune files. If the chassis containing Mediatune is to have cards which are not

desired to work within the Mediatune interface, it is very important to isolate the IP

addresses of these cards so that Mediatune cannot see them. Please contact Technicolor if

you need assistance with this configuration.

TV Mode

Most commonly, Mediatune will be used in “TV Mode”, where it will act as a software matrix

switch to control which content is being sent to each QAM channel or zone. The QAM6 will

need to first be configured in a manner best suited for the property. The default

recommendation by Technicolor would be to assign A=30, B=34, C=38 in the QAM

configuration page. Mediatune always have 2X the license count for available channels in

the interface. If License Count = 6, then there will be 12 independent output channels or

zones. If the License Count = 8, then 16 zones, etc…

Mediatune is configured so that the first zone will be port 17 on the QAM, and the second

zone is port 18. Since this is an HD product only, the third zone will be 33 and the fourth

zone is 34. The below table indicates how zones are mapped within the Mediatune interface

and how these correspond to the QAM outputs per the default QAM settings.

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Technicolor Mediatune Guía de instalación Pagina 5